8th May 2007 at 16:06 BST by Dr C.A.Jenner MB BS, FRCA. Permalink.
Patient Information Sheet – Thoracic Nerve Root Blocks
A nerve root block is typically an injection onto the sheath surrounding a nerve root in the spine. The aim of a nerve root block is to decrease the pain temporarily and then define it more precisely.
A selective nerve root block is primarily used to diagnose the specific source of nerve root pain and secondarily, for therapeutic relief of low back pain and/or leg pain.
Pain relief from the procedure of a nerve root block varies from minimal to long-term, depending on the specific symptoms.
A thoracic (of mid back) nerve root block is carried out to indicate towards the nerve causing pain by placing temporary numbing medicine over the nerve root of concern.
If the usual pain improves after the injection, the nerve in concern is most likely causing the pain. By confirming or denying the exact source of pain, it provides information facilitating proper treatment that may further include additional nerve blocks or surgery at a specific level.
A procedure for thoracic nerve root block generally follows the below listed steps:
Once the procedure is over, the physician will ask the patient to imitate something that would normally bring about the usual pain. The patient is then asked to report the percentage of pain relief and record the relief experienced during the next week on a post injection evaluation sheet.
In addition, the arms, chest wall or legs may also feel weak or numb for a few hours after the procedure.
The following set of precautions is normally advised for a patient about to undergo a thoracic nerve root block:
‘Patient Information Sheet – Thoracic Nerve Root Blocks’ was posted by Dr C.A.Jenner MB BS, FRCA on 8th May 2007 at 16:06 BST and filed under patient information sheets.
Subscribe to RSS for Articles . What is RSS?
.jpg)
© London Pain Consultants 2006. Telephone: 0845 045 0250.